Now, as a small agricultural machinery, almost every farmer has a small micro cultivator at home for operation. Sometimes there are some small problems with the micro cultivator. What if you carry out simple repair and maintenance?
First of all, the micro tiller adopts gear transmission, which has no damage to power, wide tillage width, deep tillage and strong compliance. All kinds of soil can be easily handled with high efficiency. The micro cultivator may have problems in use. After the problems appear, the micro cultivator should stop repairing in time. The repairman must be logical. The following is the four step repair method of micro cultivator.
1. The use of micro cultivator is the cleaning of the site and the machine. The working environment of micro cultivator is a lot of soil. Therefore, when the micro cultivator is faulty, choose a clean site and clean the machine before repairing it. Otherwise, if a small component is lost, it may miss work and time. After 14 hours of using the 4WD micro cultivator for the first time, the oil shall be replaced, the new oil shall be replaced and the first maintenance shall be carried out.
2. Preparation and selection of tools there are many centers of this machine, which must be disassembled and assembled with special tools, otherwise it is easy to be damaged and must not be disassembled and assembled by force. So choose the right tools and be ready.
3. Principle of disassembly: assemble first and then parts, and place them in pieces and order. At the same time, pay attention to the mark, gap, direction and screw return. If necessary, make a mark or record with a pen.
4. Assemble and clean all accessories in the reverse order of the disassembly of the micro tiller. The last one is not many, one is not many. Otherwise, it is easy to cause danger.
Secondly, maintenance of micro tiller:
Due to the seasonality, the micro cultivator is in the parking stage most of the time. Many people put the micro tiller at will after using it, regardless of whether they ask. This will have a great impact on the service life of the micro cultivator. Therefore, the following four points must be done well in the storage and treatment of micro Cultivator:
(A) The engine of diesel micro cultivator runs at low speed for 5 minutes. After shutdown, drain the oil and fill it with new oil.
(B) Remove the oil filling bolt on the engine cylinder cover and fill 1-2 oil.
(C) Properly maintain the engine of the micro cultivator, press and hold the pressure reducing handle of the engine, and pull the recoil starting rope for 2-3 times (but do not drive). Then put the decompression handle back to the compression position and slowly pull the Okinawa back until you feel pressure.
(D) The transmission should also be protected. The machines and tools shall be washed and dried, and parked in a dry and safe place.